Bobcat Miner 300 Hotspot HNT Helium
Bobcat Miner 300 is a high-efficiency miner hotspot for HNT. It is compatible with Helium LongFi, an architecture that combines the leading wireless LoRaWAN protocol and the Helium Blockchain technology.
The Bobcat Miner 300 runs on ultra-low power consumption (uses as little power as a 5W light bulb). Its enhanced 4dbi antenna provides wider network coverage, meaning better Proof of Coverage result for increased HNT earnings.
Bobcat Miner 300 is a Bobcat IoT hotspot device, which is compatible with Helium
LongFi, which combines the leading wireless LongFi protocol and helium blockchain
Bobcat Miner 300 is also compatible with all LongFi devices.
Bobcat Miner 300 operates with ultra-low power consumption (5W) and its signal
range, can cover more than 10 miles, and provide connections to thousands of LongFi
end nodes detected within its range.
Details Bobcat Miner 300 Hotspot HNT Helium
The hotspot of Bobcat Miner 300 integrates LongFi packet forwarded and Helium
Miner. The hotspot does not send the received LongFi terminal data packet to the
LongFi Network Server first, but forwards it to Helium Miner, and then forwards it
to the Console (Network Server) via the Miner, and then pushes it to the application
platform via the API interface.
Open the Helium App in your phone, register to enter, and select “Set up Hotspot”.
Then select Bobcat Miner 300 equipment to enter, you can read the network configuration
instructions first, or select “Skip” to operate step by step according to the prompts on the page.
Insert the AC plug end of the power adapter into the 220VAC mains socket, and the other end of
the DC12V output plug into the power jack of the device, as shown in the figure below. After
plugging in the power, the LED of the gateway turns red and then yellow.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.